It’s something to do with how the dimmer gets set using the FALSE flag in the apron.flt file. Tomorrow tackle the external light controls… Provide extra information to complete the original description of the issue:įrom : However, the Interior Light Rotary Dials all seem to function. Strobe Ident Selector (E) does not change pattern (yet). However, after this if you use Exterior Lights Master Switch (C) to off & would like on again, you will have to cycle from OFF to Norm- Twice. Pos/Form Dials will now function and will be set to max and can then be adjusted. To clarify-It is the Position (A) & Formation (B) Rotary Dials not functioning. You can do better from photos, but the perspective issues still applies.Do you have the same issue if you follow the OP’s steps to reproduce it? You can only make approximate estimates from the best FS cockpit model. So, I believe you have to know the exact dimensions of a cockpit if you want to make an accurate model either as a FS interior model or a physical pit. But if you had those dimensions it would not matter if your FS model was accurate or not. If you knew the exact dimensions of a display you could scale from that. Could work for a main panel, but tough for side consoles. Now, if you could work out the exact distance from the eyepoint to the panel, You could begin to take care of the perspective issue. You can see the outlines of the displays and the edges of the canopy, but perspective still applies and you can not scale the displays accurately because you do not know the distance you are from them nor the angle that they subtend. You can import the interior mdl file into ModelConvertorX and view it in wireframe. You may be able to work out the precise distance between the edges of the canopy from 3 view drawings, but you can not scale from that distance. What does that give you? The distance between the left and right edges of the canopy can be measured in pixels on your screenshot, but you can not scale from that because the screen shot has perspective applied so the azimuth scale is non-linear. Take a screenshot facing forwards, save it. OK, you have what you believe is an accurate FS model, then what? How do you work out the dimensions accurately? Every view you have in FS has perspective applied to it. Questions about SimConnect can be posted in the SimConnect forum.Īny other question that is not specific to an aspect of development or tool can be posted in the General chat forum.īy following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.Questions about terrain design can be posted in the FS2020 terrain design forum.Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course. Questions about airport design can be posted in the FS2020 airport design forum.Questions about aircraft design can be posted in the Aircraft design forum.Either post them in the subforum of the modelling tool you use or in the general forum if they are general. Questions about making 3D assets can be posted in the 3D asset design forum.Tag FS2020 specific questions with the MSFS2020 tag.So therefore we would like to ask you all to use the following guidelines when posting your questions: But having all questions about FS2020 in one forum becomes a bit messy. Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |